Some Installing Tips And Tricks For Ptfe Ring Gasket Users

By Author: Pranjal Polymers
Total Articles: 43
Comment this article

The gaskets are used to seal the joints of flanges and pipelines liquid or gas inside. The chemical industries, pharmaceuticals, oil and gas industries and many more carry toxic acids through the pipelines. They need protection against the leakage of such acids and chemicals to keep the environment safe because emission of such acids can cause damage to the man as well as the machines. There are many safety products like Flange Guards, Spray Guards, Bellow Guards, Earthing Jumpers, etc. are installed at the joints of pipelines to prevent the leakage of harmful fluids. The gaskets are used for the same. Moreover, they are available in various sizes and materials for every industry.

The main function of the product is to seal the liquid inside and prevent it from coming out. The product is available in the metallic, semi-metallic and non-metallic versions to provide complete protection to the acid industries. Among the various types of gaskets available in the market, PTFE Ring Gasket is the famous for the same purpose.

Before Installing The Gaskets For Your Flange, Valve Or Pipeline Joints You Are Required To Gather ...
... The Following Information:-

Size: Check whether the pipe size is normal and flange class. If the size is non-standard, you need:

ID and OD
Bolting dimensions
Thickness of the material
Temperature: Whether it is acid or alkaline, the temperature of the chemical matters most because it is not necessary that every material is heat-resistant. Check if the temperature is normal or more than usual.

Pressure: The flow of the chemical and pressure of the system is required for the consideration. Either there is operating pressure or maximum pressure, choose the product wisely.

Nature Of The Chemical: The pipelines carrying the chemical could be caustic, steam or acid. Check the chemical strength of the material before the installation.

PTFE Ring Gasket Installing Tips For The Chemical Industries:-

Before you install the gasket, remove the old gasket and clear the dirt and debris on the surface of the joints. You might need metal flange scrapper or aerosol gasket remover for this step. Don't neglect as this can cause failure in the process of installation.
Use ring type gaskets how far it is possible because full face types have more holes and extreme pressure cut them easily.
Avoid the usage of metallic gaskets and assure the finish of the surface as well as the flatness. Both should be satisfactory for the complete process.

Tighten all the bolts properly for precise operation.

Pranjal Polymers is a well known Flange Guards Manufacturers and PP Flange Guards Suppliers based in Maharashtra India.
Visit: http://www.pranjalpolymers.co.in