Tips To Remove That Dent

By Author: josh
Total Articles: 14
Comment this article

There are a lot ways that a dent could be removed or repaired. A lot of auto shops have dent removal Bronx services. Here are a few tips that will make it easier to remove that dent:

1. No grease, no wax
Make sure that there are no grease or wax if you want a dent removal Manhattan. This can be done with a use of a simple grease remover. There are a lot of grease removers available in stores so there shouldn’t be any difficulty in finding one.

2. A clean car
A clean car will also help in dent repair Yonkers. However, the thing to be careful of here is to not use a regular car soap. Use a dish washing soap instead. This might seem weird but the reason behind this is that when you use a regular car soap, it leaves residues of wax and silicone which can make it more difficult to repair the dent. Since there will be some tools that would be used during the repair, you don’t want them slipping off because of the wax.

3. Bring on the hammer
This tip is for all the DIYers out there. But it goes without saying you should be careful when you try to do this. If you can access both sides of the ...
... dent, you can try using a hammer to straighten out the dent. This what you typically see when someone does a dent repair Westchester.

4. Bring in the heat
This is also a common process in dent removal New York, heat shrinking. By using some ice cubes and a shrinking hammer, you can shrink any metal. But you also need to have some heat source to expand the metal before shrinking it with the coolness of the ice. This change in size of the metal can cause some dent to just pop out straight. It’s like a nifty science experiment. But one should be cautious in using the heat source. Too much heat can cause more damage to your car.

5. The Filler
Once the metal has straightened, the job is not yet finished. A body filler should be applied on your car. But before the application, the old coating is remove. But be sure to keep an eye when removing the old coating because you don’t want too much of the metal removed. The body filler will then be applied to even out the area of the dent and they spray painted. Again, be sure that the color you are using matches that of your car.