Bare Metal Os Deployment

By Author: Igor Chekushkin
Total Articles: 32
Comment this article

A bare metal environment can be described as a computer or a network system which has already been installed with a virtual machine (a multi-user resource which has the ability to give the user the impression that they are in control of a computer or a network) on the hardware instead of it being installed on the host operating system. The term bare metal usually refers to a hard drive which is usually used as a medium through which the necessary operating system will be installed.

During the process of bare metal OS deployment, an operating bare machine uses a system center configuration. This is easier and efficient to use. The system center configuration manager is used to perform the zero touch installation while the deployment is being carried out. Using this manager, the user has the ability to configure only a specific windows system which is currently present in the concernedcomputer. This manager has a SCCM client which is installed and will enable the installation of a new operating system on it.it is worthy to note that when using this, you have the ability to target a system which does not have a history of ...
... being previously installed with an operating system.

When using the SCCM procedure to deploy an operating system, you might be face with complications, especially when you don’t have perfect knowledge concerning how this work. This is mostly caused by use of hard terms which are very difficult to clearly understand. Some of these terms include: un-provisioned, computer node among other. A clear understanding of this is quite important when carrying out an effective bare metal OS deployment.

An advance in technology hasled to effective methods of operating systems deployment. Currently the use of R2 for SCCM is being used. Previously use of OSD was the most preferred method. It involved creating a record for the system in the SCCM database. A new record has been added to this new technology. Previously, you had to advertise your OSD task sequence to the collection of the concernedrecord. Knowledge of GUID, SMBIO or MAC address was of very much importance.
SMBIO GUID is easily found in the CMOS BIOS. For users who have a preference for PXE service point, they are in a position to easily boot bare metal in the PXE.They can easily check the PXE screen or even check the SMSPXE. From here you can easily lo into the system. All this has to be performed on a pre-installed operating system.

This script Cscript addComputerRecordToSCCM.vbsis usually used to prompt for the name of the concerned SCCM computer from the collecting point. The MAC address is also used during collection of relevant ID for the computer resources being used by this. By looking at given properties of a collection, you can easily see the collection ID.
The use of R2 has introduced a computer support which will move any necessary need for pre creating a record in the database. This is quite necessary for OSD. It usually works with a PXE boot and a Boot media.it usually creates two resources and these resources are added to a new collection which will have been created.

When you enable the unknown computer support, you are in a position to advertise the OSD task sequence to this collection. In those systems which uses un-provisioned systems their SMs have the ability to receive OSD task sequence. Once an operating system is installed, the system usually removes any un-provisioned computer node. In case you might need to enable an unknown computer support, all you have to do is click on the enable unknown computer support. This is usuallyreferred to as PXE service point configuration.