A Guide Ride To The Ways Of Refilling Cartomizers

By Author: Darren Swan
Total Articles: 29
Comment this article

Cartomizer is one of the crucial components of e-cigarettes. Usually, they come within a very cheap price range. Hence, a number of people prefer trashing them just after using it for once. But throwing away a device which is in a perfect condition isn’t wise at all. Instead, you can consider refilling it as you can save a few bucks this way. Want to know about the easiest methods of refilling this device? Here are the two popular ways:

The Drip Method

This is the most easiest and popular way for refilling such device. You just need to follow the simple steps laid below:

• First of all, remove the top end plastic cap using some sharp tool such as thumbtack. Make sure the tool you use should make a hole large enough so that you can fill e-liquid into it conveniently.
• But prior to dripping the liquid inside, make sure the wicking material has no burn marks. If it is burnt, then the e-liquid’s taste will turn nasty, no matter how fresh it is. So, it is wise to replace the cartridge with a new one.
• Now its time to drip the liquid inside. Hold it at a slightly angled position and ...
... then start filling it with the liquid.
• Make sure not to drip the liquid into the cartridge’s centre. The filler material should be dripped on the sides.
• Then evenly spread the liquid until it turns saturated. The standard-sized devices hold around 25 to 30 drops.
• If a puddle gets formed at the top of the material and doesn’t get absorbed even after three seconds it means that it is overfilled.
• Well, you need not to panic. Just remove the excess liquid with a paper towel. And your device is ready for use.

Once you are done with the refilling procedure wait for sometime. Allow your device to avoid burns and wick the liquid properly. Then place back the cap and screw the battery in. And your device is ready to be used.

Push Method

There a few of users who don’t prefer tinging apart the device. This method is best for such people.

• For refilling it through push method, you need a rubber cover that is present on both the ends of the device. It should not have a centre seal.
• Drop around 10 drops of the liquid into it and then insert your device all the way down towards the cover using the battery connector.
• This will force the liquid into cartridge and eventually it’ll be absorbed by the filling device.
• Pull it out, after a few minutes. Then wipe out the excess juice using a paper towel.
• You need to repeat the same process untill the liquid no more gets absorbed by the device.

So, don’t think anymore and just pick your favourite e-liquid and enjoy vaping. But, you need to keep in mind that the design of this part of e-cig falls under the category of disposables. Hence, after some uses the atomizer burns out or starts producing less amount of vapor. In order to prolong the life of your equipment you should refill it before the e-liquid is sucked completely.