Not To Neglect These Diamond Circular Saw Blade Finishing Tips

By Author: Jason Carter
Total Articles: 61
Comment this article

Do you know the importance of using diamond circular saw blade rightly? On the one hand, some security incidents should be avoided, on the other hands, both cutting efficiency and saw blade’s long working life can be guaranteed very well. OK, after learning these importance tips, you should follow these tip below to keep them in good condition.

Firstly, At fixed period, finishing tools used in the toolholder should be rotated about 1/8 circle so as to keep the sharpness of finishing tool all the time.

Secondly, sometimes when you notice that the diamond circular saw blade become blunt or flat obviously, you should adjust or even change it in time. In addition to saw blade itself, if there is the same condition happened on tool bit, you should take the same measure.

Thirdly, according to the different diameter sizes of grinding wheels, you have to choose the reasonable diamond, at this time, you have to consider the content of karat, which is the content of pure diamond. As usual, with larger grinding wheel diameter, it is better to choose diamond with larger content of karat.

Fourthly, when placing ...
... the diamond finishing tool heads on the holder, you should be more careful and please not to make it hit against grinding wheel surface.

Fifth, it is not allowed to make diamond finishing tool head with single point aim at the center of grinding wheel vertically, as usual, there should be a little tilt, about 10 degree to 15 degree.

Sixth, if the diamond circular saw blade is too much hot, it is not right to take quenching measures instantly, which means such high temperature circular saw blade is likely to become cold suddenly. If you want to take drying finishing, you have ensure the interval time between two finishing task is enough so as to ensure the sufficient cooling of finishing tool.

Seventh, if possible, every time for diamond saw blade finishing, the finishing amount should be less than 0.001 inch on the grinding wheel radius. Otherwise with too much large finishing amount, diamond finishing tool head is likely to be abraded and even damage easily. On the other hands, it is not allowed to have too much small margin. If grinding wheel has been used on some old machine tool or the one with poor stiffness, it is not right to be take finishing work because the final result would be poor and both time and energy will be wasted.

Different Circular Saw Blades including Wood Saw Blades and Panel Saw Blades are offered at Flostools, one professional circular saw blades manufacturer. In addition, Aluminum Saw Blades is also available at affordable price.