Five General Knowledge When Using Saw Blade

By Author: Jason Carter
Total Articles: 61
Comment this article

Do you know these cutting knowledge when using saw blades? After reading this article below I am sure you would get some new understanding on this topic?

Firstly, idle operation. The idle operation is the most important when the new matrix is used for the first time and as usual, the best idle operation time should be about 30 minutes. In the hot temperature summer, the idle operation should be carried out with enough water. By the way, the influence on matrix from welding tool bit should be greatly removed, therefore even under high-speed revolution, the saw blade’s condition can be kept very well.

Secondly, raw materials should not be less than 0.5 cubic meter and meanwhile it should be placed steadily. At its bottom, there should be mats which are used to fix it location firmly. As for the location, the raw materials should be at the symmetrical location with working table so that both the working table and raw materials should be firm. Both the shake and tremble should not be allowed.

Thirdly, according to the raw materials’ size including its length, width and height, the position limit switch should ...
... be adjusted so that during the up and down process of saw blade, it would be in the dependable and effective limits. Before cutting and sawing, please make sure that the tool edge of saw blade should be far away about 10mm or 20mm from the raw materials. After cutting, the saw bite should be about 20mm to 40mm from raw materials bottom. Before saw blade goes in front of both the right side and left side of knife rest, it should be quit the raw materials saw bite completely, the distance should not be less than 150mm to 200mm, otherwise saw blade is easy to hit against raw materials.

Fourthly, when the saw blade idle operation is stable, it is time to take a try to cut, meanwhile, it is not allowed to start saw blade when the saw blade cutting edge comes into contact with raw materials. During the cutting process, please not to stop working when the saw blade is still in materials, on the contrary, it should be stop rotating when saw bite is far away from materials.

Fifth, during the cutting process, if there is shake on materials, you should stop cutting instantly and then you have to fix the raw materials firmly before starting the cutting work again. By the way, please not to move materials at random.

Let me introduce Flostools to you, which is the professional Circular Saw Blade manufacturer in China. You can get Wood Saw Blades, together with Aluminum Saw Blades at here with affordable price.