Use Baby Changing Station For Your Little Baby

By Author: Michle Steve
Total Articles: 9
Comment this article

Koala bear care infant changing station helps to keep the house clean because changing diapers is a messy work. If the diaper is changed on the bed or on the table, it would certainly leave some stains on the table cloth. It makes the place filthy and it increases more work on people who are usually already burdened with a lot more work to do. But in koala bear changing station, there is chance to happen this. Genuine Koala bear care changing station comes in four colors like cream, grey and white granite and earth. The Koala changing station is made of exclusive Microban protection and enhanced operator materials. It improves sanitation and is embedded in the FDA approved blow molded high-density polyethylene bed coat.


The Koala care baby changing station has supported steel-on-steel hinge mechanism and metal mounting chassis and it also includes mounting hardware. The changing station has labeled usage instructions and safety messages in four languages. The outlined changing surface area is 450 sq. in (11,430 sq. mm) and it arrives with nylon safety strap and two ...
... bag hooks. The interlacing dual cavity liner container applies approximately 50 KB150-99 bed liners. The surface mounted horizontal design baby changing station follows the ADA requirements when installed properly. The horizontal design permits for easy approach. Koala care products of the division of Bobrick manufactures the most well known baby changing station in the industry.


The Koala bear kare adjusts to several standards for safety and accessibility. Commercial infant changing station is designed to fit into even the smallest of restrooms. Horizontal design only allows the baby to roll towards the wall and the parent greatly reduces the liability. It is constructed of high density polyethylene plastic that holds up to 400 lbs of static weight and is impervious to mold and mildew. It is designed with three important factors in mind like safety or space-saving, design and durability. This commercial baby changing station is equipped with a bed that drops horizontally rather than vertically. The curved bed allows the baby to only roll toward the wall or the changing parent before securing the nylon safety belt. A vertical drop would permit the baby to roll off either side which doubles liability.


It fits inside even the room is smallest. When in a closed position, it designs only 4½ inches from the wall, and in case of opened it is 18½ inches. This uncommon design permits the customers to pass the changing parent while in use. It even allows the option of installation inside a restroom stall for maximum privacy. It is designed of high density polyethylene plastic. It is impenetrable to odors, mold and mildew, and can be easily cleaned. A pneumatic air pump is used for controlled depressing and recantation of the changing bed. It is designed to bear up to 400 lbs. of stable weight. The restroom baby changing station provides protection from hooliganism and as well as a greater sense of safety for parents or providers and facility managers.