How To Secure Your Netgear Router

By Author: Eva Smith
Total Articles: 25
Comment this article

The Wireless Netgear router is extensively used but it has some security fear. If you have got the Netgear router, then securing is the main concern because it has your IP and admin username, password are all stored in it. This permits access to only some trustworthy persons to access the router or network. You must enable the wireless security for your router. Present routers are more advanced because of many improvements in technology so your wireless router’s range is much more improved and it has been better. So now the risk of being tapped into your internet connection is also enhanced. The first important thing you must do is to purchase a wireless router that is trustworthy and trustworthy for the security purpose.

While purchase your networking device, you must connect your ie modem to the back WAN slot of your router. One time it has been connected, you can construct the settings. You must protect your router by password protect your wireless router. If you wish to save and secure your private and confidential information and put off it from unofficial access then you must know to secure your router settings. ...
... These unauthorized people can steal your personal data and important information and give you a lot of tensions for the moment or without end by having benefit of your insecure wireless connection. So here are some important and very useful information for enabling security, you just need to follow these steps:

1. First of all you have to log in to router web interface by typing http:\\192.168.0.1 or http:\\192.168.1.1 in your web address bar.

2. Mostly every router has the username as admin and password as password so your log in detail must be same. The username must be admin and Password should be password if you have not changed it.

3. Now you must click wireless settings below setup

4. You need to make security as WEP

5. Here you should keep your Security type as automatic

6. Your router’s encryption strength is 64 bit

7. You need to put a check mark on key 1 & type in any 10 digit key & apply the settings.

8. Try to connect to your wireless network from your wireless computer which will prompt you to enter the wep key. Now enter the 10 digit key & verify the same and click connect.

9. At present you have enable wep for your wireless network and it's protected and safe now.

IveeraSupport in an independent technical support provider for Netgear Router Setup related problems including Wi-Fi setup, configuration, security, and upgrade etc. If you are looking for Netgear Router Support, You can reach online technical support at their Toll Free No 1-888-897-5899 For US/CA.