The Integrated Usb Green Laster Pointer

By Author: ellian
Total Articles: 93
Comment this article

Switches are off the normal position of all switches are off the normal position of the name of the pressure switch 12 RS-232 TINI configuration described, the switch to open the communication via RS-232 interfaceBlue Laser Pointer (Ethernet disabled). the RS-232 interface (or optical fiber) to connect to the TINI board. for the TINI board configuration and programming. Ethernet is disabled. 3 4 TINI Flash fiber RS-232 TINI board short-term memory can also be written by RS-232 TINI programming interface. to make the optical fiber through the AUX connector board communications (Ethernet disabled).The integrated USB 100mW laser pointer receiver contains three more chips. Table 3.3 Motherboard 3.1.5 Motherboard switch SW2 switch replacement forms replace motherboard, follow these steps 1) to ensure that there is an alternate board the correct type (level / vertical) receiver unit D-SUB connector. If not, ...
... please contact your dealer. 2) If you can service PC and the instrument communication, the instrument settings to a file download Otherwise, this instrument has been found the most recent saved settings file and it should not be the best three months of the previous 3) Close the instrument. The three chips inside integrated USB 200mW Laser Pointer receiver all have high heat productivity.4) If the AUX board and / or receiver board installed in the main unit on the motherboard be removed must be removed before they board. Receiver mounted on top of the screen panel for open-type version: Do not touch Do not touch any of the fixed detector screws or nuts Do not touch that may damage the optical alignment. 5) Note that all ribbon the direction of the cable, plug and unplug them. When the USB receiver of green laster pointer is busy reading and writing, it would be hot. Ribbon cable for two lines, but only one is correct 6) Loosen the D-SUB on the motherboard screws (2.5mm L-shaped hex wrench) and the corner screws, and lift the motherboard out of the box 7) Disconnect from the old motherboard and CPU board option TINI board plug and put it on the motherboard installed in the new 8) to install a new motherboard in the instrument, and should be like 5) Step pointed out to connect all the cables. to ensure that the laser module ribbon cable completely centered, it plugged in, make sure the end of the ribbon cable is not damaged (if necessary with a spare ribbon cable experiment) 9) Re-install the 4) removal of part of step 10) with some of the equipment installed in the gas and turn the test unit 11) to enable the instrument to enter Sleep mode Sleep mode (by using the "Advanced" mode in the service program: "manual instrument Sleep mode control -> enter Sleep Mode ") 12) 2) Save the file as from the re-set into the instrument 13) through the" Set Variable -> Page 4 -> Finish "and" Update instrument "calibration modulation parameter 14) to clear all error messages (there may be some) and set the instrument clock. 15) to reset the instrument and wait for it to start the measurement. 16)But the temperature inside the 5mW laser pointer could reach upmost 60 ℃. If an error message, see "User Manual" Part 5, and 2.10 of this manual part 17) as 3.7 part as described in checking the absorption line position 18) If necessary, such as 3.9 parts described as adjusting the laser temperature to find the correct absorption lines.