The Integrated Micro Sd Green Laster Pointer

By Author: ELLIAN
Total Articles: 93
Comment this article

RS232 and services for personal computer communication with the ribbon cable, RS232 and RS232 PC services, and services personal computers 7 Keyboard module for the optional use of ribbon cable, the keyboard 8 for "change change" procedure used by the circuit outlet. to change the name of the connector (part in bold above) printed on the motherboard near the connector Note ribbon cable can be connected in two ways. connection Plug 1 with a 2 mm white emphasis identity. ribbon cable side of the red (or other color difference) and plug a line laser module ribbon cable is no different color, but should adapt with the laser module 1 with the connector plug. 3.1.2 The heat productivity of the common 100mW laser pointer receiver is low so it feels warm. There are many motherboards motherboard LED power indicator for light-emitting diodes with. Table 3.1 shows the light-emitting diodes list of green light-emitting diodes should be properly lit, and the red and yellow diode is usually not lit Note TINI board of several ...
... red LED does not follow this rule LED print the name of the small body in the motherboard, according to Table 3.2 shows light-emitting diodes 8, 9 and 10 form a group. The integrated Micro SD 200mW Laser Pointer receiver has a USB HUB chip and a card reader chip inside. LED2 light-emitting diode lasers name LED6 LED1 LED3 LED4 describe the color green power (+18 V-+36 V), the fuse before the green power, +5 V digital green power,-15V analog (for the board and receiver board) Green Power, +15 V analog (for the board and receiver board) Green Power, +24 V analog (for 4-20mA current loop input) LED12 LED13 LED5 green power, +5 V, the green power for the AD converter,-5V, Green Power for the AD converter, +5 V, DA converter for laser modulation LED7 yellow laser unprotected in the open relay laser (laser on) point of LED8 LED9 LED10 LED11 red error (see table 3.2 below) Yellow COM (see table 3.2 below) the green can (see table 3.2 below) the red form of overloading the system 3.1 light-emitting diode lasers motherboard error (red) COM (yellow) error (red) COM (yellow) ON OFF  Flashing flashing flashing can switch XX (green) (green) OFF ON reset signal is activated switch description.So the heat productivity of integrated Micro SD green laster pointer receiver is high. The TEC Disable / Enable RS-232 communication network or no communication RS-232 switch is pressure activated switch activates the configuration X = any possible values (on, off or flashing) 3.2 Form error error-COM-COM-OK light-emitting diode lasers combined 3.1 .3 motherboard fuse on the motherboard to use only one fuse located near the power input connector D-SUB corner. fuse from the "Wickmann" production, model TR-5 F1A (ie 1 amp, fast) in the Ethernet there is a spare connector near the fuse board installed in the power input is a positive and negative input terminals, the protection diode in the opposite direction if the power accident connected with opposite polarity, the diode circuit, the fuse may be blown. correct polarity, the broken fuse can only point the light-emitting diode laser 2 while all other LEDs turn off the laser identification. 3.1.4 board switch board has the following switches: The integrated USB 5mW laser pointer receiver has the highest heat productivity. Switch 1: The reset button and it will force the instrument to restart , can also be used as a power off and turn on an option to restart the instrument. Switch 2: a variety of communication options for the TINI board programming switches and switch 3.3 switch set in the form of four switches is mainly used for production of all all SW2 The normal position of switches are closed. Blue Laser Pointer