How To Apply Damask Wallpaper

By Author: Vikram kumar
Total Articles: 9790
Comment this article

When applying wallpaper in the home, it is important to have the right tools for the job. This also goes with applying brick wallpaper as well as damask wallpaper. Both must be put onto the walls in a professional manner and with the correct tools used in the process. It is also helpful to know something about installing wallpaper in the home and preparing the walls for the paper.

Before you begin applying damask wallpaper on the walls, you should prime the walls first. This will make it easier to remove the paper from the plaster walls at a time when you feel that it is desirable to do so. Once the walls are primed, it is then time to begin. Be sure to follow the directions on the primer and wait for it to dry in order to start applying the wallpaper.

Applying damask is just the same as applying brick wallpaper. It is important for the design to match throughout the room as well as the seams to be properly put down. You never want to cut at a corner, either, when applying wallpaper. There are tools that will make it easier to install the paper in the corner without cutting it to make it fit. When ...
... applying any sort of wallpaper, it is best to have it in the roll and cut into pieces, not small pieces but sections that are large enough to cover as much of the wall as you can get in one go. The pieces of paper should reside in water to activate the glue. Most paper today has glue on the backing and is thus easier to apply than that which has to be glued prior to use.

You never want to hang paper dry as this will make it more difficult and will also allow for seams to pop. Good paper is thick enough to withstand the water soak and will then go on the walls easily and much more smoothly than trying to apply it with as little moisture as possible. Therefore, soaking the paper in water prior to use is the best method - much better than trying to wet the back before applying. The system of having all of the paper in water, in pieces that just need to be pulled and then applied works well to retain the continuity of the design.

A smoothing tool is then used on the paper to make sure that it goes on without any sort of buckles. This will make it lay smoothly upon the wall. When applying the first section, be sure to use a level to make sure that it is all straight. It is also a good idea to start with the most focal point of the room as all rooms are not usually completely square and may slope in some areas. Therefore, you should start at the most focal area of the room and work your way towards areas that are not as visible. Once you get the first strip up, it is easier to continue in this fashion.

Author Bio.

Installing Damask wallpaper is not difficult as long as you have the right tools and knowledge. To learn more about how to get damask and Brick wallpaper for less go to Your 4 Walls.