Safety Operation Rules Of Laser Cutters

By Author: anywaylaser
Total Articles: 15
Comment this article

It is very dangerous when laser cutters break down during working. The newcomer who can do independent operation should be trained by professional personnel. The experts of laser engravers have already summarized 13 details about safety operation rules of these laser machines. Now I can share these ideas to you and hope it would be helpful.
Now you can see the following tips:
1.Observe generally safety operation procedures of laser cutters. Start laser generators in strict accordance with the set-up procedure of lasers.
2.The operator should be trained, very familiar with the structure and performance of laser engravers or laser cutters, and grasp related knowledge of operating system.
3.Dress labor protection articles according to regulations. Must wear protective glasses if you are near to the laser beam.
4.If you are not clear whether certain material can be used for laser irradiation or heating, you should not ...
... process it to avoid the dangerous of generating smoke or vapor.
5.Once laser cutters start, the operator shall not leave post or ask others to guard arbitrarily. If need to leave, the operator should stop the equipment or cut off power.
6.Put the fire extinguishers in readily accessible areas. Turn off laser generators or light gate when not process. Don’t put paper, cloth or other tinder near to laser beam without protection.
7.Immediately stop laser engravers or laser cutters if there are abnormal conditions during working. And the operator promptly eliminate malfunction or report to competent personnel.
8.Keep laser generators, lathe bed and surroundings neat, orderly, no greasy dirt; put workpiece, panel and waste according to regulations.
9.When use gasbottle, it should not crush the welding electric wire lest leakage accidents. The gas bottle’s use and transportation need to comply with gasbottle supervision regulations. Prohibit gasbottle in sunlight basking or near heat source. When open valve, the operator must stand in the bottle mouth side.
10. When maintain laser cutters, you should abide by high pressure safety procedures.
11.After startup, you should start machine in manual low-speed X, Y direction and check to make sure whether there is any abnormal situation or not.
12.After input the new job program, the operator should try test run and check its operation situation.
13.During working, the operator needs to watch the conditions of machine tool to avoid laser cutters running out of effective working range.