Ws-sup32-ge-3b & Ws-sup720-3bxl

By Author: Alex Rist
Total Articles: 45
Comment this article

The Cisco Catalyst 6500 Series Supervisor Engine 32, the next generation of
Supervisor Engine for Cisco Catalyst 6500 Series switches for a modular wiring
closet. Supervisor Engine 32 with Policy Feature Card 3B (PFC3B), covers the key
innovations in the network edge. adducible industry-leading Cisco Catalyst 6500
Series Supervisor Engine 720 technology, the Cisco systems Catalyst 6500 Series
Supervisor Engine 32 allows customers to cost-effectively enable hardware-based
security features, such as denial of service (DoS) mitigation to protect
performance of network applications, and scalable support for multicast
applications, the network edge.
PFC3B speed limiters offer CPU,
hardware-based MAC learning, and user fee based on the limitation. Limit the
threat of the Dynamic Host Configuration Protocol (DHCP), default gateway, or
end user IP address spoofing with features such as DHCP Snooping, Dynamic
Address Resolution Protocol and the evaluation period Source Guard. The
supervisor engine allows directors accented at the end with ...
... which users can
contact the network and privileged to be allowed through identity-based networks
of the IEEE 802.1x standard, the port-based security, and lists port-based
access. These security features are hardware based and can be activated at the
same time without compromising the system as traffic levels build up.

Cisco Catalyst
6500 Series Supervisor Engine 720 WS-SUP32-GE-3B offers a sharp component,
preferably a door in the wiring closet point. It comes standard with regard to
PFC3B Supervisor Engine 32 offers feature adaptation of the pilot with the 720
engine Supervisor Engine 32 comes in two versions: 8x1 Gigabit Ethernet (GE)
Small Form Factor Pluggable (SFP)-based ports or 2x10 GE XENPAK-based ports.
Supervisor Engine 32 requires a high fan speed when running on a Cisco Catalyst
6500 chassis. As such, at least 2500W AC (110V or 220V mode) or DC operation is
required in 6 -, 9 - and 13-slot chassis. It requires at least 950 W and 3-slot
chassis. Supervisor Engine 32 can also serve as the E-Series chassis or Cisco
7600 series routers.

The Cisco Catalyst 7600 Series Supervisor Engine 720
is a family of Supervisor Engines to deliver scalable IP premeditated and
carried out discharge base in the hardware. Its feature set enables applications
based on hardware, such as using IP routing, Layer 2 and Layer 3 Multiprotocol
Label Switching VPN Ethernet over MPLS with Quality of Service and security
settings. The
Cisco systems Catalyst 7600 Series Supervisor Engine 720 WS-SUP720-3BXL
integrates a high performance 720 Gbps crossbar switch fabric with a motor drive
in a single article, which provides 40 Gbps of switching place (for 4-10GE ports
and 48 10/100/1000 ports density line cards). With hardware-enabled forwarding
for IPv4, IPv6 and MPLS, the performance of the system is subject to 400 Mpps
for IPv4, 200 Mpps for IPv6 traffic, with a configuration and 1024 LIF each
population with more than 700 routes VRF for MPLS.
The Supervisor Engine 720
builds on the confirmed Cisco Express Forwarding architecture, by bolstering
centralized forwarding ) and distributed forwarding. The variants of PFC3
characterize the various Supervisor 720 families of engines. There are three ,
PFC3A, PFC3B and PFC3BXL, correspond to WS-SUP720, WS-SUP720-3B and
WS-SUP720-3BXL. The Supervisor Engine 720 family is supported on both operating
systems-Cisco Catalyst IOS and Cisco IOS
Cisco
Supervisor Engine 720 offers a powerful set of security features. The security
system has been hardened to support features such as Port Security, CPU rate
limiting, Multi-Path uRPF 802.1x, and a long list of plug-ins. Extensive feature
support such as QoS mechanisms, hardware-based generic-routing-encapsulation
tunneling, and Access Control List allows customers to create powerful and rich
networks.
For more info please visit baynetwork.com