Selecting Remote Access Configuration

By Author: Shirley Green
Total Articles: 129
Comment this article

Remember, this option provides significant help in setting up a secure A+ certification connection. Refer to the guidelines for more information.
5.Select VPN for the access type, and click Next.
6.Select the external interface as the interface connected to the Internet, and click Next.
PPTP and L2TP over IPSec packet filters will be automatically configured for the interface, and all other traffic will be blocked.
7.Select a specific range of addresses, and add the range 192.168.7.100 through 192.168.7.150.This range of address represents addresses not assigned on the internal network. They will be available for assignment.
8.Repeat these steps on the Tailspin Toys server, but use a different IP address range: 192.168.10.100 through 192.168.10.150.
This will be the user account used for PPP authentication to the Wingtip Toys site by the Tailspin Toys VPN router. The wizard will create this account on the Wingtip Toys computer. See the guidelines for the importance of setting a strong password CompTIA A+ certification ...
... for this account.
11. Enter the Dial Out Credentials, as shown in Figure 7-14. These are the user name and password for the Tailspin Toys VPN router. (The name is in the table from the previous exercise.) Click Next, and then click Finish.

The Wingtip Toys router will use this account to authenticate to the Tailspin Toys router. When you configure the demand-dial interface for the Tailspin Toys router, you must be sure to use this name to name the interface and use the password entered here for the Dial In Credentials in the wizard.
12.In the details pane of the console, right-click the demand-dial interface just created and select Properties.
13.Verify that the IP address entered is the address of the Tailspin Toys VPN router.
14.Select the Security tab, and then select the Advanced (Custom Settings) option and click the Settings button.
15.In the data encryption free practice tests drop-down box, select the Maximum Strength Encryption(Disconnect if Server Declines) option, as shown in Figure 7-15.This will require 128-bit encryption.