A Step By Step Guide To Re-grouting Wall Tiles

By Author: The joins between tiles can often become pretty di
Total Articles: 403
Comment this article

The joins between tiles can often become pretty dingy and it will be a good idea to re-grout them from time to time. This is actually a very simple task to carry out and it will make a dramatic improvement to the overall look of your tiles!

Follow this step by step guide and give your tiled wall a new lease of life!

1. ‘Out with the Old.'

Using a tile raker, scrape along each line of grout that has to be removed. Take care not to slip and damage any of the tiles as you will need to press on quite hard. It is advisable to work on a small area at a time.

2. Cleaning/Preparation.

When all of the old grouting has been scraped out, take plenty of time to clean each join. Any dust or lumps of old tile adhesives from the raked-out areas will need to be removed and every join should be left as clean as possible

3. ‘In With the New.'

Spread your new grout between each of the tiles. Make sure that it is all pushed in properly and that no air bubbles are present. Remove as ...
... much excess grout as you can whilst you are working. Once you have finished, clean around the edges of your tiles with a damp cloth.

4. Finishing Off.

When the grout has partially dried, you will need to run a length of dowel along each join; this will result in a nice even finish! Ensure that any streaks are wiped away from the surface of your tiles and give each one a polish with a soft cotton cloth.