Leaky Faucet? Fix It Yourself In 5 Easy Steps

By Author: Shofia Den
Total Articles: 22
Comment this article

Water spillage could seem to be a minor inconvenience. However, a defective tap can waste a lot of water. Also, the constant commotion can be enough to make anybody angry! Fortunately, fixing a defective tap is a simple task. It is something that you can tackle yourself in an hour. Also, the tools required can be found at plumbing supplies in Sechelt. So, grab your wrench and follow these 5 easy steps to silence that pesky drip!
1) Safety first
You must turn off the water supply to the faucet. You can do this by locating the supply taps. They are usually underneath the sink in the cabinet. There should be separate ones for hot and cold water. You need to turn them clockwise until they stop completely.
2) Remove the handle
Most faucets have a small screw hidden under a decorative cap. You need to remove it and pull the handle straight up. This can help to detach it from the tap's stem. You can also apply a little penetrating oil around the base if the handle is stuck. You can get these items at plumbing supplies Sechelt. This can help to loosen things up. Don't use excessive ...
... force. This is because you might damage the handle.
3) Access the packing nut and washer
Now you'll see the packing nut. This is what holds the faucet stem in place. You need to utilize a wrench to loosen the nut. You can do this by turning it on the left side. In any case, you should be mindful not to tighten it too much when you reassemble it. When the nut is loose, you should be able to remove the unit. After this, you want to check the washer for any indications of damage. This is the most likely culprit behind the leak.
4) Replace the washer or O-ring
You need to replace the old wash ring with a new one of the exact same size. Some faucets might have an O-ring instead. In this case, you need to replace it as well. You can get them at plumbing supplies Sechelt.
5) Reassemble and test
You need to carefully screw the faucet stem back in and place the new washer in its designated spot. Then, tighten the packing nut with the wrench. But don't crank it down too hard. You just want it snug. After this, you can reattach the faucet handle. You also need to secure it with the screw and put the decorative cap back on. Now, turn the water supply valves and test your faucet.
To conclude
These were the 5 easy steps to fix your leaking faucet. First, you need to get the necessary tools from plumbing supplies in Sechelt. After this, you need to turn the valves off. Then, you need to remove the handle and washer. Carefully inspect them, and if necessary, you can replace them. Lastly, you need to reassemble and test your unit.
This article's author is Shofia Den. For additional information regarding Plumbing supplies Sechelt please continue browsing our website at noblebc.ca.