70-297 Introduction

By Author: Alyssa
Total Articles: 127
Comment this article

To create an RSoP query with the Resultant Set Of Policy Wizard Planning mode, com¬plete the (free Cisco certification exam questions) following steps:

1. Click Start, and then click Run.

2. In the Run dialog box, type mmc in the Open box, and then click OK.

3. In the MMC, from the File menu, click Add/Remove Snap-In.

4. In the Add/Remove Snap-In dialog box, click Add.

5. In the Add Standalone Snap-In dialog box, select Resultant Set Of Policy, click

Add, and then click Close.

6. In the Acid/Remove Snap-In dialog box, click OK.

7. In the MMC, right-click the Resultant Set Of Policy icon on the RSoP Wizard con¬

sole, and then select Generate RSoP Data.

8. In the Welcome To The Resultant Set Of Policy Wizard page, click Next.

9. On the Mode Selection page, shown previously in Figure 11-1, select Planning Mode, then click Next.

10. On the User And Computer Selection page, shown in Figure 11-5, type the name of the target user in the User Information ...
... box and the target computer in the Computer Information box. To search for a user or computer, click Browse. Click Next.

lit Set of Policy Wizard

11. On the Advanced Simulation Options page, shown in Figure 11-6, do any or none of the following:

Q If you want to simulate a slow network connection, select the Slow Network Connection check box.

Q If you want to simulate the loopback processing mode, select the Loopback Processing check box. Then select Replace Mode or Merge Mode.

Click Replace Mode to indicate that the user policies that are defined in the computer's GPOs replace the user policies that are normally applied to the user.

Click Merge Mode to indicate that the user policies that are defined in the computer's GPOs and the user policies that are normally applied to the user are combined. Recall that if the policy settings conflict, the user policies in the computer's GPOs take precedence over the user's normal policies.

12. In the Site list, select the site that the RSoP query uses, if desired. You select a site if you want to test policy and (free Microsoft question papers) where startup or logging on occurs on another subnet than the one on "which the query is currently being run. Click Next.

Tip If at any time while navigating the Resultant Set Of Policy Wizard you have finished entering information for your RSoP simulation, select the Skip To The Final Page Of This Wizard Without Collecting Additional Data check box and click Next.
If you want to know more on the area, you sign in our website of (70-297 Exam) to see more.