Aluminium 8011 Plate Exporters In Chennai

By Author: Sidharth Mehta
Total Articles: 13
Comment this article

In the case of Aluminium 8011 H18, the alloy is cold worked severely such that it equals an approximate fo 75% reduction in are. The other common temper designation is T14, where the material is Strain hardened, or what is also referred to as cold worked. Cold working the 8011 Aluminium Coil is minus thermal treatment and is half hard. One of the benefits of using this temper is that the alloy gets resistant to cracking 8011 Aluminum Foil, permitting the worker to either emboss or deboss this material without becoming susceptible to cracking. The Aluminium 8011 Thermal Conductivity is about 237 W/mk. Lastly, aside from increased strength due to tempering, the 8011 Aluminum Material Properties include excellent surface properties, for instance - good wettability and decent resistance to corrosion.

Divine Metal & Alloy A wrought alloy grade, alumiun 8011 is an alloy that contains a high content of silicon in its chemical composition. To bring about the best in the alloys, it is very common for the 8011 Aluminium Foil to be tempered. Usually, tempers designated as H14 & H18 are practiced on this grade. The letter ...
... designation H indicates that the alloy is tempered by strain-hardening. Strain hardening is considered to be ab ideal choice for non-heat-treatable alloys such as Din 3.4144 Shim Sheet. This is because strain hardening tends to improve their strength. A temper such as strain hardening is practiced typically at room temperature.

Aluminium 8011 Plates Specificaton
Specifications Chart ASTM B209 / ASME SB209
Dimension Chart ASME, ASTM, and API
Thickness Table in MM 0.2~300 Milimeter
Width in mm 500~2500 Milimeter
Length in mm 500~10000 Milimeter
Tempers H34, H24, T4, F, T5, H14, H22, H36, H18, H19, T851 T451, H26, T3, T351, H32, H112, H16, O, T7, H321, T651, T6, H111, H12, H38,
Surface Finish polished, Bright, hair line, sand blast, brush, checkered, etching, embossed, etc.
Forms Foils, Coils, Rolls, Strip, Checkered Plate, Flats, Circle, Blank, Ring (Flange) etc.
Coating Color Coated, PVC Coated, Polyester, polyurethane, Fluorocarbon, epoxy coating
Finishes Mill, Customer specific finish
Chemical Composition
Grade Si Fe Cu Zn Mn Mg Ti Cr Al Others(Total)
Aluminium 0.40 – 0.80 0.70 max 0.15-0.40 0.25 max 0.15 0.8-1.2 0.15 max 0.04-0.35 Balance 0.15 max