Tips For Better Cut Quality With A Rotary Cutter

By Author: Neil Roy
Total Articles: 26
Comment this article

A Rotary cutter is a machine that helps in cutting the overgrown weeds in the fields, which helps in controlling the pastures. These cutters can be adjusted to cut in lower and higher growth. Rotary cutters are also attached to the back of tractors to cut grass and brush on agricultural land. There are several tips to improve the quality of the cutting with Rotary Cutters. Some of those are-
●The first thing you should always notice while using a rotary cutter is that you should keep everything clean and use a lubricant.
●Power take of a stub is very important for rotary cutters. To improve your cut quality, you should adjust your rotary cutter with the recommended tractor power cut of stub speed.
●When the materials on the field are heavy, you should decrease the speed of the tractor for better cutting.
●The heights of the rotary cutters can be adjusted to lower and upper heights. But to improve your cutting, you should always adjust it to a lower height, which also helps in better suction of the blade.
●Always check before cutting that the blades of the rotary cutter ...
... should be sharp and undamaged. It is also important to install the correct blades in the correct places.
●The gearbox must have the correct amount of parts, and it's a must to rotate them in the correct direction.
●In the case of row crops, there may be some stripes left if the crop is very dense. By changing the direction of the blades, you can improve the circulation inside the cutting chamber, which improves the cutting in that case. In row crop conditions, with cutters with anti-windrow deflectors, streakings may occur when the crop is pushed to the sides by the deflectors. Cutting the ideal position in the deflectors in line with crop rows may allow the crops to enter the cutting chamber easily and improve the quality of cutting.
●You should always check the wings to center section leveling and should also verify the settings of the airbag suspension. One should also use blades of 1 to 1.5 inches, which allows the materials to quickly leave the cutting section. Also, one should install distribution ramps on the cutter wing section. By installing distribution ramps on the cutting wing section, what will happen is that one can improve the spreading of materials behind the cutter of a rotary cutter.
●By installing anti-window deflectors, one can improve the cutting as it helps in preventing the materials from going into the center part in a rotary cutter rather it throws the materials out of the center part.

Conclusion

Even though some streakings are very usual in sharp turns, still you can reduce this by adjusting the tractor trade spacing which should be wider than the cutter hinge area, and by also following the aforesaid tips and tricks.
Neil Roy is the author of this article.To know more about Rotary Cutters please stay with our website:schulte.ca