How To Undertake Cornice Installation In Residential Property

By Author: Cody Dugdale
Total Articles: 151
Comment this article

Even though installing a cornice is a simple job, it still requires a lot of attention to detail. A cornice is an element of architectural construction that can be used as a decorative moulding around the top of interior walls or as a projection above an exterior wall. In residential property, it's usually made from wood, plaster, ceramic tiles, or stone.
 
In this article, we'll walk you through the process of installing a cornice in Sydney. The first thing you'll need to do is measure the length and height of your cornice. You can find these measurements by measuring the room's wall or door trim. Once you've done that, you'll need to figure out how much wood you'll need to order from a lumberyard or home improvement store.
 
If you are planning to install a cornice in your home, there are several things that you should keep in mind. First, make sure that the surface where you'll be working is safe for this type of installation. Second, choose the best type of cornice for your project and don't forget ...
... to measure the length and height of the wall where you'll be placing it. And finally, remember to leave enough space between the ceiling and the bottom edge of the cornice for electrical wiring.
 
Below we have listed some helpful tips for undertaking this type of installation in residential property:
 

Ensure that the surface you're working on is completely secure and stable enough to support this type of installation by performing a thorough inspection with appropriate tools (screwdriver).

Choose a proper type of cornice for your project.

Make sure you measure correctly and take all necessary measurements.

Remember to leave enough space for improvisation.

When installing a new cornice in Sydney, you are responsible for ensuring that the edges of the cornice are even. This means that if your walls are uneven, this is something you'll have to fix before installing the cornice. It is not a project for the inexperienced DIYer, since it requires a very precise eye and an extremely steady hand.

There are two basic techniques for installing a cornice: mortise and tenon, or butt joint. Both require precise measurements and quality workmanship from you. If you're using butt joints, ensure that the ends of each board fit tightly into one another-these are what will hold your cornice up, so don't slack on them! Measure twice before cutting once on this step, just in case an error was made during your measurements; cutting the wrong size piece can be disastrous!

About the Author: This contribution has been made by Cody Dugdale who has written a number of articles on Cornice Installation Sydney and provides fruitful information. To know more, please visit gyprockers.com.au