What Is The Process Of Pool Fence Installation In Australia

By Author: Pool Perf
Total Articles: 5
Comment this article

In Australia, pool fencing is mandatory, and if it isn't complied with, then there is a chance of a potential safety hazard as well as enforceable by the law. Hence, it is best to install pool fencing to avoid such issues.
Benefits of using Pool Perf
Pool Perf manufactures custom made aluminum perforated pool safety fencing. These have been tested to the standard of Australia and tend to comply with the council swimming pool regulations as well. Pool fencing is made easy through Pool Perf. It helps in changing your view by helping you choose a beautiful plain screen and other designs, which allow privacy along with easy to clean features and a lot of breezes. However, to install the pool fence, it is important to check out the location of the underground services, especially the gas, electricity and plumbing. This is an important step that needs to be followed in pool fencing.
Here are a few steps you need to take before pool fence installation:
Checking the location
This is the first and main thing which ...
... should be done. The underground plumbing, electricity and gas should be considered without that, and there will be a lot of problems you can face, e.g. hitting the underground pipes and cables while installing the fence.
Preparing the tools and the materials
This is the second thing that needs to be checked pre-installation and before pool fencing. All the tools for pool fencing should be there, including the post hole digger, the screwdriver, and electric drill, along with a pencil or chalk as well. Make sure you have a strong tape measure and a spirit level along with a concrete mix. Once you have collected all of these things, start with the installation process for pool fencing.
These are the following steps that need to be followed for pool fences installation:

Evacuation of holes

One of the fence panels is used as a spacer, and a strong is used to guide the direction. Then the holes are excavated for the fence posts. The size and the depth of the holes usually depend on the fence size and type of pool fencing.

Positioning

Make sure you position the posts within the holes, and the string is run across the top of each post whenever it is placed to ensure the alignment is correct and levelled.

Alignment and filling

Once you ensure that the alignment is correct and everyone approves of the sizes, start filling the holes with concrete.

Securing the panels into the posts

Slide the panel brackets over the top rail and the base rail, and then use temp block to lift each panel into its appropriate positioning. Secure the panels to the posts once it is positioned properly.

Attaching the gate latch

Once the gate is in position, attach the gate latch and close the gate with it in the appropriate and approved position. Make sure you adjust the hinges to make sure that the gate closes automatically from any open position.
Conclusion
In conclusion, pool fencing is an important part of Australia's law, and it is meant to protect children and keep everyone safe from any safety hazards. Pool fencing isn't very hard to install, especially when you know a place that could help you go through the process without any trouble.