7 Proper Steps To Follow When Wiring Your House

By Author: John Smith
Total Articles: 1
Comment this article

Wiring a house is one of the most crucial aspects when shifting in a newly built house. Usually, some skilled professionals help in wiring electrical systems due to their complexities. Few individuals normally use wire or wiring system in there house under the direction of an electrician. However, these professionals charge expensive fees that cost too much for a normal Samaritan. And the process of wiring is not that complex as we think it is. So, through this blog we will try to learn 7 steps that will help you in wiring your house.

Here are the steps that we need to follow while wiring our house.

Formulate a Writing Diagram
The first and the most basic step when wiring your house is to design a writing diagram. It will help you in giving an idea about the positioning of the wires and sockets. Also, the writing diagram will locate the breaker box to each outlet.

Install Conduits
When installing conduits, start by running the longest wires to avoid the wastage of conduits. If not done properly you will face the shortage of wire. The right way to do it is to start with each wire upstairs and ...
... pull it through to the basement. While installing wires you must leave at least one foot of extra wire at each end so that you can move things around later if required.

Remember Outlet Count
When wiring a house knowing the outlet count becomes important. An individual must specify how many outlets and switches will run on one circuit when wiring his/her house. Generally six outlet per a 110-Voltage circuit is advisable in a room. Different areas of a house have different voltage circuit requirements. So, to safe your house from a short-circuit remembering the outlet count becomes important.

Drilling Wire Holes
The most suitable option for making a wire hole is using a drill. However, when drilling any holes one must make sure that he/she is not drilling across a wire or a duct work. In simple words, one must know what is on the other side of the wall. Usually, a 1-inch bit is used to drill a hole in the middle of the studs. It is safer to have to more outlets in your home as it reduce the chances of short-circuit.

Establish a breaker
After drilling holes and establishing outlets, one must set a breaker in a place which is easily accessible. Basements are the most ideal place to have a breaker.

Pull the wires to the outlets
You need to place the roll of wire next to your breaker box and pull the wire according to your diagram to the closest outlet or switch. You can also run the wires straight through the box if possible. One must make sure that no wires are sticking out of the box. Electricians also advise to use wire strippers to remove the outer plastic coating from the ends of the wire and attach them to the instructions on the box at each outlet, fixture or switch.

Install the circuits
The final step in the process of wiring a house is installation of circuits. Individual circuits should be installed for each wiring set and must match the amperage of the wire.

This Article is written by the Author on behalf of Elite Air Climate Control having topics on wire or wiring systems and many more. Please visit https://eliteairsydney.com.au/electrical/ for more information.