How To Make The Proper Use Of A Diamond Blade In The Construction Field?

By Author: Mark Bruddy
Total Articles: 52
Comment this article

The proper use of a diamond blade in the construction field requires more than just a good diamond blade and a machine. Knowledge of how diamond blades are designed to perform is significant. Once the blade is in the field; it is up to the cutting operator to apply a blade to the job at hand in a profitable manner. There are many variables that affect diamond blade performance in the construction field.

Let's have a look at how to make the proper use of a diamond blade in the construction industry.

Tensioning

Diamond Blades are tensioned by the manufacturer to run at the recommended rpm. Tensioning is specifically designed to keep blades from distorting at high speeds. The blade will straighten when it is rotated at the optimum speed. The tensioning can be achieved by a mechanical roller hammersmith or otherwise called roller tensioning machine.

If the designed speed is not attained, the blade may wander as the cutting begins. When the blade is in tension phase, it vibrates and wanders when placed in the cut.

Machine Drive Power

When optimizing the cost-effectiveness ...
... of any diamond saw blade another factor to consider is the amount of power available to the blade. Diamond cutting tools require optimal pressure for maximum performance. Adequate pressure must be applied to maintain sharp cutting crystals.

Troubleshooting

Some more common problems that are encountered in the construction fields along with their remedies are:

Loss of tension in a diamond saw blade:

There are reasons for loss of tension in a diamond saw blade. The blade core may overheat due to a lack of sufficient water applied to the blade resulting from uneven segment wear. Make sure that the water supply is reaching near the collars. One should use a blade better suited to the cutting application.

Blade tension may be lost when blade flanges are not of the exact size, or when a blade is misaligned on the saw. One should ensure that the flanges are clean, are of the proper size.

The operator should not exert pressure on the blades by pushing, mounting, jamming or twisting. All these actions can put unwanted stress on the blade and cause metal distortion.

A blade that will not cut may not be the proper one. The operator should observe the segments on the diamond blade to find out the exact reason why it is not cutting. Knowing as much as possible about the concrete can be advantageous to the cutting operator and the tool manufacturer. If the surface of the segment is quite smooth and the diamonds are not extending beyond their limits, then the diamond bond combination is not right for the application.

Mark Bruddy is an expert who previously worked in a manufacturer and distributing company of Brick Diamond Blades and Diamond Saw Blades. He has years of experience of working with this hard material and its available benefits.