Good Reasons Why Monocrystalline Solar Panels Are The Industry Standard

By Author: michellumb55
Total Articles: 3025
Comment this article

For the last couple of years, the monocrystalline photovoltaic electric solar panels have been the choice of many people. Their advantages apart from being the oldest are that they are reliable, efficient, dependent and have amazing ways to produce electricity from the sun. Every single module of the monocrystalline solar panels is made from a single silicon crystal. Though quite pricey, it is more efficient as compared to the cheaper polycrystalline solar panels. You can easily notice the monocrystalline solar panels by their color, which is black or iridescent blue. The following are the reasons why the monocrystalline solar panels are the choice of many people.
Efficiency

Expert Monocrystalline Solar Panels manufacturers are the most used monocrystalline solar panels. They have an efficiency rate of 22.5%. In June 2010, a record was broken where monocrystalline solar panels produced were at 24.2%.

Benefits Of Monocrystalline Solar Panels

The advantages of the monocrystalline solar panels are definitely compared to other types of solar panel technologies. Here are 8 reasons why people choose ...
... monocrystalline solar technology.

Longevity

The monocrystalline solar panels have been in existence and around for such a long time. This has been great evidence of how long they can existence or their longevity. When it comes to issues of their technology, installation and performance, they are all understood. Some of the panels that were installed in the 1970s are still producing electricity today. The single crystal panels have even withstood the rigors of space travel.

Efficiency

As had been initially mentioned, the pv panels which are made from the mocrystalline solar cells are able to convert the highest amount of solar energy into electricity. If you have an aim of producing a lot of electricity, the monocrystalline solar panels should be what to go for.

Lower Installation Costs

When comparing the installation cost of a fully installed solar power system, the monocrystalline solar panels are typically 60% of that full installation cost. Installation therefore becomes a significant cost component. While this has certainly not been completely verified yet, there is an Australian installer who has reported that amorphous thin film panels need more mounting rails and this makes the installation process longer. This would therefore mean an additional cost.

Embodied Energy

Monocrystalline Silicon panels require a little less effort and energy when it comes to their installation. Thin-film solar panels on the other hand are quite the opposite when it comes to the energy. They have a lower embedded energy level and require more time for installation.

Greater Heat Resistance

Once the sunlight temperature goes to a level of around fifty degrees, or a hundred and fifteen degrees, the monocrystalline solar modules will suffer a reduction in output. The levels of reduction expected are between twelve and fifteen percent. This is definitely a loss and when compared to what’s experienced by PV panels made from the polycrystalline cells, this means a deduction in production which translates to heat resistance.

Find more information relating to Monocrystalline Silicon, and Monocrystalline Solar Panels here.