The Basics Of Setting Up The Cs108 Handheld Reader

By Author: RFID4UStore
Total Articles: 11
Comment this article

Left Side of the CS108

There are 5 LEDs on this side, from left to right, respectively:

RFID Power On
Status
Barcode Power On
Charging
External Power connected – This light corresponds to the blue trigger located on the grip handle of the reader, which allows for manual activation of RFID reading capabilities.

Fig 03: CS108 Left side View

The Right Side of the CS108

There is a 2 combination button/LED on this side.
The right button/LED is for the main power.
When the LED lights up GREEN, this means power is on.
Hold this button for 3 seconds, then release to power on (must release before it powers on). To power of, do the same thing. Hold the button for 3 seconds and release.
The left button/LED is for Bluetooth pairing. When this LED lights up BLUE, it means Bluetooth is connected.
When first powered up, the Bluetooth LED will automatically start flashing to indicate that it is now discoverable by a smart device nearby. From the Application on the smart device, one can then connect to the CS108.
After connection, the LED will stop blinking and remain lit. At any time, to stop the Bluetooth connection, hold the Bluetooth button for 3 seconds until the LED turns off.
To restart Bluetooth and pair with a device, hold the Bluetooth button until the Bluetooth LED starts flashing and reconnect via the application.

Fig 04: Right Side View

Pairing the CS108 to a Computer via Bluetooth

The reader will need to be connected to the computer using Windows® standard.

Add the Bluetooth Device process prior to using it with any RFID Applications.

Use the following steps to navigate to the Bluetooth settings on your computer:

Start Menu > Settings > Devices > Bluetooth & other devices (See Below- Figure 04)

Fig 05: Windows Settings

To Add CS108 Bluetooth Reader in Windows PC

Turn on your CS108 and make it discoverable by holding down the Bluetooth button until the LED starts flashing.
Turn on Bluetooth on your PC, if it's not on already. To do this, select the Start button, then select Settings > Devices > Bluetooth & other devices, and turn on Bluetooth.
Select Add Bluetooth or other devices > Bluetooth (Refer Fig 05).
Select Add Device > Bluetooth
Discover available CS108
Select the CS108XXXXXXXXXX (Refer Fig 06).
Enter the password and click Pair. The password for CS108 is 00000.
Once the connection is completed, a success message will popup (Refer Fig 07).

Fig 06. Windows® 10 Bluetooth & other devices

Fig 07. Windows® 10 Add a device window