Files Not Restoring From .bkf File

By Author: webchamp
Total Articles: 50
Comment this article

NTBackup is a well known backup tool, which comes inbuilt with Windows Operating System. It helps in safeguarding the data in times of data corruption due to unforeseen reasons. Therefore, it's always recommended to create .BKF file using NTBackup utility for backing up the data. Doing this helps a lot in times of data crisis when no solution is left to restore the files and folders.

But sometimes even the backup .BKF files get corrupt and we tend to lose all hope of getting back our previous data. As everything has certain flaws, same is the case with the .BKF file. Sometimes, the BKF also gets corrupted; due to which user might fail to open BKF file to restore the data. Consequently, the files stored in the .bkf file cannot be used or accessed further. Now if you have backed up the data at some other place, may be on other storage media then your data is saved. Otherwise you would be in need of third party software to Open BKF file and to restore the data there after.

Consider a situation when you try to restore your files using NTBackup utility. ...
... But, you notice that the files are not getting restored properly instead you encountering error messages.

After this, you are left helpless as the .bkf file cannot be used further to restore the backed up data.

Cause

The main causes for this unusual behavior of the .BKF file could be:

1 . A third-party backup software has set the below mentioned value to 1 while getting installed. But, the NTBackup utility sets it to 0.

HKEY_CURRENT_USER\SOFTWARE\Microsoft\Ntbackup\Backup Engine\Backup files inuse

Actually the main issue is that you have tried to backup those files which were open, due to which the .bkf file has become corrupted.

2 . Another main could be missing files from the .BKF file. This happens when the value of the above mentioned entry is set to 0, the backup utility skips the open files, as a result of which some files might be missing while restoring from the .bkf file.

Resolution to this problem

Consider the following steps to resolve the problem:

3 . Firstly, you need to set the following value to 0.

HKEY_CURRENT_USER\SOFTWARE\Microsoft\Ntbackup\Backup Engine\Backup files inuse.

4 . Make sure that the file is consistent before you backup.

By following the above resolution you would be able to open BKF file in most of the cases. But what if it fails to do so? You are left with the choice of using third party application that open BKF in an accurate and timely manner. Software repair corrupt backup files make it appropriate for use by individuals who need to recover data from corrupt or inaccessible BKF files.

For more information about

Visit for site

www.openbkf.net