Precautions When Using Potato Digger Cropper

By Author: yang huimin
Total Articles: 132
Comment this article

With the increase in potato production, the enthusiasm of farmers to buy new types of agricultural machinery is also getting higher and higher, but many farmers tend to ignore some precautions before using the newly purchased agricultural machinery. Today, Aike Machinery will introduce it to everyone. Buy some aspects of the agricultural machine potato excavator cropper that need to be noticed before use.
The Farming machine potato digger cropper mounted agriculture tractor has to be noted:
First, read the instructions. After the new equipment is purchased, the engine should be carefully read before using the engine. Pay special attention to the use of the specified grade of diesel oil. Pre-sedimentation and filtration should be carried out before use. The oiler should be kept clean.
The second is to pay attention to the lubricating oil should be kept clean, add enough oil, and replace it regularly, the use of the brand should be consistent with the regulations.
Third, air filtration should always pay attention to maintenance, pay attention to adding cooling water, especially not to make the engine work ...
... in the state of water shortage.
Fourth, always pay attention to the inspection, tighten the relevant bolts, nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nut on the flywheel, the tightening nut of the wheel. If the user buys a new one and then does it according to the basic requirements, then the life of the machine can be greatly extended.
The fifth is to test run-in, after purchasing a new machine, do not immediately carry the load operation, it should be tested and run in accordance with the requirements of the manual. After the end of the running-in, clean the machine oil filter and remove the residual impurities in the oil. If necessary, replace the oil and clean the oil pan.
Sixth is not overloaded work. When the potato digger cropper is working, it must be done in strict accordance with the manufacturer's instructions. It is not overloaded, does not overspeed, does not feed, and does not work for a long time.
Seventh, it is not possible to modify the equipment and arbitrarily increase the engine speed. In order to make the machine run fast, some users arbitrarily adjust the oil supply and supply pressure of the high-pressure oil pump. Some of them also tie the speed-regulating spring with a wire, which is even more wrong.
https://www.taakthreshermachine.com/tractor-mounted-potato-harvester/