Custom Dissertation

By Author: Payel Guha
Total Articles: 73
Comment this article

Custom dissertation will be written as per the needs. Though the basics of writing a dissertation will be same in custom dissertation also but some fine tuning is required considering the requirement of the consumer.
Mainly a research has two stages.
1) Planning and preparation- At the outset, the research should be properly planned. If the object of the research is clearly known and the research is well planned, it can be systematically and successfully conducted.
Pre decision regarding the method of data collection, degrees of accuracy, type of information to be collected etc. are necessary for obtaining valid and complete data. Selection and training of enumerators and appointment of supervisory staff should be done. The plan of tabulation and presentation should be prepared in advance. The characteristics which are to be studied and the methods that are to be adopted for the analysis should be pre determined. Proper outline for interpretation of data should be formed. A well planned research is likely to give results of highest precision.
2) Execution of the survey- After planning and making all the ...
... preparations of the
Research, the research is executed. The execution has four steps, namely i) Collection of data, (ii) Scrutiny, editing and presentation of data (iii) Analysis of data and (iv) interpretation of analyzed data.
(i) Collection of data- The validity of research inferences depends mainly on the data on which they are based. Incomplete and defective data lead to invalid conclusions. Thus, data should be collected with utmost care and hence, the stage of collection carries much importance. During the time of collection, the supervisory staff should ensure that enumerators are prompt in collecting accurate data. If there is non response from any unit, special efforts should be made to secure data from such units.
(ii) Scrutiny, editing and presentation of data- The collected data should be scrutinized for reliability, consistency and completeness. The volume of data can be reduced by systematically arranging them in the form of tables. The tabulate data, if necessary, may be represented by diagrams and graphs.
(iii) Analysis of data- The data are analyzed by using statistical devices and techniques. Statistical constants such as averages, measures of variation, correlation, tend etc. are derived. With the help of the derived values, assumptions or hypothesis regarding the population are tested. The validity and reliability of the whole research processes should be maintained at every level of analysis.
(iv) Interpretation of analyzed data- the final decisions are based on the analyzed facts. Based on these facts, inferences should be carefully made. Regarding the final conclusion, a report should be prepared. At the time of writing the report the requirements of the consumer should be kept in mind and the report should be arranged as per the requirements.
These are the general processes of making any dissertation paper. Depending on the requirements of the consumer you need to change your methods for doing research and also of writing the dissertation. But the basic tenets of making any research paper should always be the same.

PayelDis is an academic writer who provides useful information about thesis and custom dissertations .