Now Replace Your Cracked Samsung Galaxy S7 Edge Screen In Less Than 10 Minutes

By Author: UK Wide Repair
Total Articles: 271
Comment this article

Samsung Galaxy S7 Edge is undoubtedly the flagship smart phone between the beast. Its curved Corning gorilla glass screen makes a more stylish display than it looks stronger. However, it is not completely free from damage. Before you break the screen, you can follow the steps listed here to fix it quickly.

Listed special tools can be easily purchased online, or even from the local mobile repair shop rented for one or two hours. If you are not familiar with the layout, you may need a visual guide to help you identify the parts. Here are the steps to replace the broken screen of Galaxy S7.

• Turn off the device and remove the SIM card tray.

• Heat the rear of the equipment with a hot water gun or a blower until it becomes too hot to come into contact.

• Place the suction cup on the back of the device.

• Pry the back of the device to insert a thin metal nozzle.

• Slide the nozzle along the connector and remove the rear cover. Insert a business card or card to prevent the back cover from being sealed. Do not use credit cards because they ...
... are too thick. After separating the entire edge, slowly remove the back cover.

• Use the Phillip Phillips screwdriver to remove the 12 Phillip screws that secure the rear housing.

• Next, use the plastic separation tool to separate the top plastic support. Then remove the wireless charging board.

• Disconnect the battery cable, power cord, display cable, and power button cable.

• Use tweezers to disconnect the speaker module.

• Pop up all antenna cables and fingerprint scanner cables.

• Disconnect the headphone connector, the front camera connector and its vicinity, and the optical sensor connector.

• You can now lift the motherboard and disconnect the charging port connector.

• Remove the rear camera.

• When you reach the battery, you may need to heat it a little to lift it with a nozzle.

• Loosen the three screws that secure the headphone jack and remove the jacks and tabs that are connected together.

• Use a hot water gun and apply some heat to the top glass panel.

• Gently press the screen assembly to create a gap between the screen and the front component. You can use the nozzle, but do not insert too deep.

• Use plastic tools or business cards to increase the gap. You may need to use tweezers to pull black adhesive.

• After cleaning the adhesive, carefully lift the screen from one side.

• Before reinstalling the other components, replace the screen and test the new screen.

• You must now reinstall all other components by backing all the steps. Use some heat activated adhesive to stick the external components together. You can also use special glue.

If you have experience using electronic equipment, the whole process is less than 10 minutes. But even beginners, if they follow the instructions, can also complete these steps. Refer to the picture or even the video may help to understand how to proceed. Now your level of experience is important, please remember to clean and dry your hands to clean any dirt and dirt. In addition, to ensure that the work surface stable and clean.

For more details, visit http://www.ukwiderepair.co.uk