Important Safety Standards For Directional Boring Technique

By Author: John Mark Lee
Total Articles: 4
Comment this article

Directional Boring is a method of fixing the pipes or cables that are under the ground. This method is carried out with the help of a drilling rig. It is a developed technique of trenching. The plus point of this technique is that it is executed without disrupting the environment or disturbing people in the surrounding area. There are different type of pipes such as, plastic, polyethylene, steel and iron which can be fixed easily without wasting any time. The pipes or cables of electricity, gas, water, telecommunication, oil or sewers are usually cost effective. This method is normally applied on a soil where there are cobblestones.

Some of the advantages of choosing directional boring technique are:

It causes less disturbances to the land and the people. There is no need for the open-cut method as the drilling equipment can pass through any obstacle that it stumbles upon the path.

Different direction holes can be drilled with this method instead of only one vertical direction, so the pipe fixing can be done in any position.

It can connect gas, oil or water resources with the land without any difficulty.

It ...
... can install pipe in any industrial or commercial area without disturbing or destroying the land.

It is an environmental friendly technique.

This drilling method is not stopped or delayed by the weather conditions.

The directional drilling method does not cause any traffic jams.

It can be used to install pipes anywhere which is why it is considered to be a flexible method.

Every method used for drilling or trenching has its advantages and disadvantages. Every method has seen its share of hazards and incidents at the project site. There is no specific technique which is safer than the other ones, but if precautions and safety measures are undertaken cautiously then such incidents can be avoided.

It is important for the workers to disclose and mark all the utilities in the area to be drilled. This can be done by calling the Dig Safe.

Once these utilities are marked, the worker must keep checking if they are in place where they should be. The Dig Safe Locator will only show the place the utility was installed and not its depth. Double check the points around the drilled path of the present utilities. Look out for the utilities that might have been missed by the locator. Keep an eye for pedestals, manholes, storm drains, etc.

The next thing is to have the right equipment according to your work and project. You must have the safety equipment. The workers are supposed to wear proper eye and ear protection, rubber gloves, and visible clothes and work shoes during every step of process.

The drilling rig or drilling head must be located to ensure it stays on the right path. Check for the obstacles that might interfere in the work.

The workers must have the right communication between them. Two radio method is the best way.

The workers should be made aware of the potential hazards and how to deal with them.

These are some of the safety standards that need to be taken care of in order to avoid any hazardous incidents.